Diagnostic Test
WARNING: This page is about a different variant/trim than selected.
- CHECK ASCD STEERING SWITCH
- Turn ignition switch OFF.
- Disconnect combination switch (spiral cable) harness connector.
- Check resistance between combination switch harness connector terminals as per the following conditions.
Combination switch (Spiral cable) Condition Resistance (Ω) Connector + - Terminal M303 13 16 MAIN switch: Pressed Approx. 0 CANCEL switch: Pressed Approx. 250 SET/COAST switch: Pressed Approx. 660 RESUME/ACCELERATE switch: Pressed Approx. 1, 480 All ASCD steering switches: Released Approx. 4, 000
Is the inspection result normal?
YES
INSPECTION END
NO
Replace steering wheel. Refer to REMOVAL AND INSTALLATION .