LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2016 >> Q50 Base, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 123 (Hybrid Motor System (Diagnostic Trouble Codes (DTCS) P2122-P31FF And Circuit Diagnosis) (Hybrid)) >> DTC / Circuit Diagnosis >> DTC P311F: Pre-Charge Relay >> Component Inspection (Pre-Charge Relay)

Component Inspection (Pre-Charge Relay)

WARNING: This page is about a different variant/trim than selected.

  1. CHECK PRE-CHARGE RELAY-1

    1. Disconnect battery junction box harness connector.
    2. Check the continuity between battery junction box harness connector terminals.
      Battery junction box Continuity
      Terminal
      24 8 Existed
    3. Also check harness for short to ground and to power.

    Is the inspection result normal?

    YES 

    GO TO STEP 2  .

    NO 

    Replace battery junction box. Refer to DISASSEMBLY AND ASSEMBLY .

  2. CHECK PRE-CHARGE RELAY-2

    Check the continuity between battery junction box harness connector terminals as per the following condition.

    Battery junction box Condition Continuity
    Terminal
    22 30 12 V direct current supply between terminals 24 and 8 of battery junction box harness connector Existed
    No current supply Not existed

    Is the inspection result normal?

    YES 

    INSPECTION END

    NO 

    Replace battery junction box. Refer to DISASSEMBLY AND ASSEMBLY .

scientia non olet · About LEMON Manuals