DTC Confirmation Procedure
WARNING: This page is about a different variant/trim than selected.
- PERFORM DTC CONFIRMATION PROCEDURE
- Set the vehicle to READY.
- Set the vehicle as the following condition and wait at least 1 minute.
A/C switch ON Accelerator pedal Depressed Selector lever P position - Turn ignition switch OFF and wait at least 60 seconds.
- Turn ignition switch ON.
- Check DTC.
Is DTC detected?
YES
Proceed to DIAGNOSIS PROCEDURE .
NO - 1
To check malfunction symptom before repair: Refer to INTERMITTENT INCIDENT .
NO - 2
Confirmation after repair: INSPECTION END