LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2016 >> Q50 Base, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 123 (Hybrid Motor System (Diagnostic Trouble Codes (DTCS) P2122-P31FF And Circuit Diagnosis) (Hybrid)) >> DTC / Circuit Diagnosis >> DTC P310A: HPCM >> DTC Logic >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.

  1. PRECONDITIONING

    If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

    GO TO STEP 2  .

  2. PERFORM DTC CONFIRMATION PROCEDURE

    1. Turn ignition switch ON.
    2. Turn ignition switch OFF and wait at least 10 seconds.
    3. Repeat step 1 and 2 for 2 times.
    4. Check 1st trip DTC.

    Is 1st trip DTC detected?

    YES 

    Proceed to DIAGNOSIS PROCEDURE .

    NO - 1 

    To check malfunction symptom before repair: Refer to INTERMITTENT INCIDENT .

    NO - 2 

    Confirmation after repair: INSPECTION END