Wheel Alignment
WARNING: This page is about a different car, the 2017 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
If the vehicle is equipped with the ICC system and the rear toe has been adjusted during a wheel alignment, the ICC sensor must be aligned. Refer to DESCRIPTION (TYPE 1) or DESCRIPTION (TYPE 2).
| Item | Standard | ||
|---|---|---|---|
| Camber Degree minute (Decimal degree) |
Minimum | -1° 20' (-1.33°) | |
| Nominal | -0° 35' (-0.58°) | ||
| Maximum | 0° 10' (0.16°) | ||
| Left and right difference | 0° 30' (0.50°) or less | ||
| Caster Degree minute (Decimal degree) |
Minimum | 3° 00' (3.00°) | |
| Nominal | 4° 20' (4.33°) | ||
| Maximum | 5° 40' (5.66°) | ||
| Left and right difference | 0° 30' (0.50°) or less | ||
| Kingpin inclination Degree minute (Decimal degree) |
Minimum | 6° 45' (6.75°) | |
| Nominal | 7° 30' (7.50°) | ||
| Maximum | 8° 15' (8.25°) | ||
| Toe-in | Total toe-in Distance |
Minimum | 0 mm (0.00 in) |
| Nominal | In 2.0 mm (In 0.079 in) | ||
| Maximum | In 4.0 mm (In 0.157 in) | ||
| Total toe angle Degree minute (Decimal Degree) |
Minimum | 0° 00' (0.00°) | |
| Nominal | In 0° 10' (In 0.17°) | ||
| Maximum | In 0° 20' (In 0.33°) | ||
Measure value under unladen * conditions.
* : Fuel, engine coolant and lubricant are full. Spare tire, jack, hand tools and mats are in designated positions.