LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2016 >> Q50 Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 169 (Automatic Transmission (Symptom Diagnosis & Removal And Installation) (Except Hybrid)) >> Unit Disassembly And Assembly >> Front Carrier, Input Clutch, Rear Internal Gear >> Disassembly

Front Carrier, Input Clutch, Rear Internal Gear: Disassembly

WARNING: This page is about a different car, the 2018 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove needle bearing SYMBOL from front carrier assembly.
    GNSJPDIA1120Z-120Courtesy of NISSAN NORTH AMERICA, INC.
  2. Compress snap ring SYMBOL using flat-bladed screwdrivers (A).
    GNSJPDIA1123Z-123Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION:
    • Be careful not to scratch rear internal gear.
    • Be careful not to damage snap ring.
  3. Remove front carrier assembly and input clutch assembly from rear internal gear.
  4. Remove front carrier assembly from input clutch assembly.
  5. Remove snap ring SYMBOL from front carrier assembly.
    GNSJPDIA1159Z-159Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Be careful not to expand snap ring excessively.
  6. Remove O-ring SYMBOL and seal rings SYMBOL from input clutch assembly.
    GNSJPDIA1124Z-124Courtesy of NISSAN NORTH AMERICA, INC.
  7. Remove needle bearing from input clutch assembly.
    G04075868Courtesy of NISSAN NORTH AMERICA, INC.
  8. Remove snap ring from input clutch drum using a flat-bladed screwdriver.
    G04075869Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION:
    • Be careful not to scratch rear input clutch drum and input clutch retaining plate.
    • Be careful not to damage snap ring.
  9. Remove input clutch component part (drive plates, driven plates, retaining plate and dish plate) from input clutch drum.
scientia non olet · About LEMON Manuals