Removal and Installation: Installation
WARNING: This page is about a different car, the 2018 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.
Note the following, and install in the reverse order of removal.
CAUTION:
- Never reuse seal rings and drain plug gasket.
- Apply petroleum jelly to needle bearing and seal rings.
- Insert the tip of parking rod between the parking pawl and the parking actuator support when assembling the rear extension assembly.
- Refer to the followings installing rear extension assembly.
- Apply recommended sealant to rear extension assembly as shown in the figure.
*
: Genuine Anaerobic Liquid Gasket or equivalent. Refer to Recommended Chemical Products and Sealants .
Sealant starting point and end-point
: Start and finish point shall be in the center of two bolts.
Overlap width of sealant starting point and end-point (B)
: 3 - 5 mm (0.12 - 0.20 in)
Sealant width (C)
: 1.0 - 2.0 mm (0.04 - 0.08 in)
Sealant height (C)
: 0.4 - 1.0 mm (0.016 - 0.04 in)
CAUTION: Completely remove all moisture, oil and old sealant, etc. from transmission case and rear extension assembly mounting surfaces. - Tighten rear extension assembly bolts to the specified torque.
: Bolt
- Apply recommended sealant to rear extension assembly as shown in the figure.
- Fill with ATF after installation. Refer to Changing .