Removal and Installation: Installation

WARNING: This page is about a different car, the 2018 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.

Note the following, and install in the reverse order of removal.

CAUTION:

Be careful not to damage connector when installing any connector.
Never reuse joint connector.
Apply ATF to O-ring of joint connector.
Never reuse drain plug and drain plug gasket. In addition, install new drain plug and drain plug gasket after adjustment of A/T fluid filling.

Refer to the following when installing the control valve & TCM to transmission case.

CAUTION:

Make sure that input speed sensor securely installs input speed sensor holes

Courtesy of NISSAN NORTH AMERICA, INC.

Hang down output speed sensor harness toward outside so as not to disturb installation of the control valve & TCM.
Adjust joint connector of the control valve & TCM to terminal hole of transmission case.

Assemble it so that manual valve

cutout is engaged with manual plate

projection.

Courtesy of NISSAN NORTH AMERICA, INC.

Install bolts and clip

to the control valve & TCM. Tighten bolt

to the specified torque before tightening the other than bolts.

Courtesy of NISSAN NORTH AMERICA, INC.

: Vehicle front

Bolt symbol	Length mm (in)	Number of bolts
	43 (1.69)	3
	40 (1.57)	2
	54 (2.13)	6
	50 (1.97)	2
*	50 (1.97)	1

*: Reamer bolt

Refer to the following when installing oil pan to transmission case.

CAUTION:

Clean foreign materials (gear wear particles) that contact on the inside of the oil pan and on the magnet, and then assembly.
Completely remove all moisture, oil and old gasket, etc. from oil pan gasket mounting surface of transmission case and oil pan.
Never reuse oil pan gasket and oil pan mounting bolts.
Install oil pan gasket in the direction to align hole position.

Tighten the oil pan mounting bolts to the specified torque in the numerical order as shown in the figure after temporarily tightening them.

Courtesy of NISSAN NORTH AMERICA, INC.

: Vehicle front

Fill with ATF after installation. Refer to Changing .