LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2016 >> Q50 Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 169 (Automatic Transmission (Symptom Diagnosis & Removal And Installation) (Except Hybrid)) >> Removal And Installation >> Control Rod >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2018 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.
  1. Shift the selector lever to "P" position.
  2. Remove nut (SYMBOL ) and remove the control rod SYMBOL from the lower lever of A/T shift selector assembly.
    GNSJSDIA4254Z-254Courtesy of NISSAN NORTH AMERICA, INC.

    SYMBOL

    : 2WD models (Not applicable)

    SYMBOL

    : AWD models

    SYMBOL

    : Vehicle front
  3. Remove nut (SYMBOL ) and remove the manual lever SYMBOL (with control rod) from transmission assembly.
    GNSJSDIA4257Z-257Courtesy of NISSAN NORTH AMERICA, INC.

    SYMBOL

    : Vehicle front
    CAUTION: When loosening manual lever mounting nut, set manual lever in "N" position and fix manual lever to prevent it from moving.
    GNSJSDIA4258Z-258Courtesy of NISSAN NORTH AMERICA, INC.

    SYMBOL

    : D position

    SYMBOL

    : N position

    SYMBOL

    : R position

    SYMBOL

    : P position
  4. Remove snap pin, control rod, conical washer, plain washers, collar, and insulator from manual lever.
scientia non olet · About LEMON Manuals