Aiming Adjustment Procedure

WARNING: This page is about a different car, the 2017 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.

Place the screen.
NOTE:
- Stop the vehicle facing the wall.
- Place the board on a plain road vertically.
Face the vehicle with the screen. Maintain 10 m (32.8 ft) between the front fog lamp center and the screen.
Start the engine. Turn the front fog lamp ON.
NOTE:
Shut off the headlamp light with the board to prevent from illuminating the adjustment screen.

CAUTION:
Never cover the lens surface with a tape etc. The lens is made of resin.

Adjust the cutoff line height

with the aiming adjustment screw so that the distance (X) between the horizontal center line of front fog lamp (H) and

becomes 100 mm (3.94 in).

Front fog lamp light distribution on the screen

Courtesy of NISSAN NORTH AMERICA, INC.

	: Cutoff line
	: High illuminance area
H	: Horizontal center line of front fog lamp
V	: Vertical center line of front fog lamp
X	: Cutoff line height