Diagnosis Procedure
- SYMPTOM CHECK 1
Check that there are pedal vibrations when the engine is started.
Do vibrations occur?
YES
GO TO STEP 2 .
NO
Check brake pedal. Refer to INSPECTION AND ADJUSTMENT .
- SYMPTOM CHECK 2
Check that motor sound from ABS actuator occurs when the engine starts.
Does the operation sound occur?
YES
GO TO STEP 3 .
NO
Perform self-diagnosis for "ABS" with CONSULT.
- SYMPTOM CHECK 3
Check symptoms when electrical component (headlamps, etc.) switches are operated.
Does the symptom occur?
YES
Check that radio (including wiring), antenna and antenna lead-in wires are not located near ABS actuator and electric unit (control unit). Move them if they are located near ABS actuator and electric unit (control unit).
NO
GO TO STEP 4 .
- PERFORM SELF-DIAGNOSIS
With CONSULT
- Turn the ignition switch OFF → ON.CAUTION:
- Be sure to wait of 10 seconds after turning ignition switch OFF or ON.
- Start the engine.
- Repeat step 1 two or more times.
- Perform self-diagnosis for "ABS".
Is any DTC detected?
YES
Check the DTC. Refer to DTC INDEX .
NO
INSPECTION END
- Turn the ignition switch OFF → ON.