Removal And Installation: Installation

Note the following, and install in the reverse order of removal.

• Never drop or strike ABS actuator and electric unit (control unit), because it has little endurance to impact. Never use a pneumatic tool.
• When installing brake tube, tighten to the specified torque using a crowfoot and torque wrench so that flare nut and brake tube are not damaged. Refer to EXPLODED VIEW WITH TORQUE SPECIFICATIONS .
• Never remove and install actuator by holding actuator harness.
• Bleed air from brake piping after installation. Refer to BLEEDING BRAKE SYSTEM .
• Never apply excessive impact to actuator, such as by dropping it.
• After installing the ABS actuator and electric unit (control unit) harness connector , push down the lever until locked.

  Courtesy of NISSAN NORTH AMERICA, INC.

• When replacing the ABS actuator and electric unit (control unit), be sure to perform the following procedure.
  • Configuration: Refer to WORK PROCEDURE .
  • Adjustment of steering angle sensor: Refer to WORK PROCEDURE .
  • Calibration of decel G sensor: Refer to WORK PROCEDURE .