Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect trunk lid opener request switch assembly connector.
3. Check signal between trunk lid opener request switch assembly harness connector and ground using oscilloscope.

   (+)		(-)	Signal (Reference value)
   Trunk lid opener request switch assembly
   Connector	Terminal
   T47	1	Ground	Courtesy of NISSAN NORTH AMERICA, INC.

Is the inspection result normal?

YES 

GO TO STEP 3  .

NO 

GO TO STEP 2  .

1. Disconnect BCM connector.
2. Check continuity between BCM harness connector and trunk lid opener request switch assembly harness connector.

   BCM		Trunk lid opener request switch assembly		Continuity
   Connector	Terminal	Connector	Terminal
   M15	83	T47	1	Existed

3. Check continuity between BCM harness connector and ground.

   BCM		Ground	Continuity
   Connector	Terminal
   M15	83		Not existed

Is the inspection result normal?

YES 

Replace BCM. Refer to REMOVAL AND INSTALLATION .

NO 

Repair or replace harness.

Check continuity between trunk lid opener request switch assembly harness connector and ground.

Is the inspection result normal?

YES 

GO TO STEP 4  .

NO 

Repair or replace harness.

Refer to COMPONENT INSPECTION .

Is the inspection result normal?

YES 

GO TO STEP 5  .

NO 

Replace trunk lid opener request switch.

Refer to INTERMITTENT INCIDENT .

INSPECTION END