Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect malfunctioning front outside handle assembly connector.
3. Check voltage between malfunctioning front outside handle assembly harness connector and ground.

   (+)			(-)	Voltage
   Front outside handle assembly
   Connector		Terminal
   Driver side	D5	1	Ground	9 - 16 V
   Passenger side	D19			Courtesy of NISSAN NORTH AMERICA, INC.

Is the inspection result normal?

YES 

GO TO STEP 3  .

NO 

GO TO STEP 2  .

1. Disconnect BCM connector.
2. Check continuity between malfunctioning front outside handle assembly harness connector and BCM harness connector.

   Front outside handle assembly			BCM		Continuity
   Connector		Terminal	Connector	Terminal
   Driver side	D5	1	M14	71	Existed
   Passenger side	D19			72

3. Check continuity between malfunctioning front outside handle assembly harness connector and ground.

   Front outside handle assembly			Ground	Continuity
   Connector		Terminal
   Driver side	D5	1		Not existed
   Passenger side	D19

Is the inspection result normal?

YES 

Replace BCM. Refer to REMOVAL AND INSTALLATION .

NO 

Repair or replace harness.

Check continuity between malfunctioning front outside handle assembly harness connector and ground.

Is the inspection result normal?

YES 

GO TO STEP 4  .

NO 

Repair or replace harness.

Refer to COMPONENT INSPECTION .

Is the inspection result normal?

YES 

GO TO STEP 5  .

NO 

Replace front door outside handle grip.

Refer to INTERMITTENT INCIDENT .

INSPECTION END