Diagnosis Procedure
- CHECK DOOR KEY CYLINDER SWITCH INPUT SIGNAL
- Turn ignition switch OFF.
- Disconnect front door lock assembly (driver side) connector.
- Check voltage between front door lock assembly (driver side) harness connector and ground.
(+) (-) Voltage Front door lock assembly (driver side) Connector Terminal D1 5 Ground 4 - 6 V 6
Is the inspection result normal?
YES
GO TO STEP 3 .
NO
GO TO STEP 2 .
- CHECK DOOR KEY CYLINDER SWITCH SIGNAL CIRCUIT
- Disconnect power window main switch connector.
- Check continuity between power window main switch harness connector and front door lock assembly (driver side) harness connector.
Power window main switch Front door lock assembly (driver side) Continuity Connector Terminal Connector Terminal D8 15 D1 6 Existed 16 5 - Check continuity between power window main switch harness connector and ground.
Power window main switch Ground Continuity Connector Terminal D8 15 Not existed 16
Is the inspection result normal?
YES
Replace power window main switch. Refer to REMOVAL AND INSTALLATION .
NO
Repair or replace harness.
- CHECK DOOR KEY CYLINDER SWITCH GROUND CIRCUIT
Check continuity between front door lock assembly (driver side) harness connector and ground.
Front door lock assembly (driver side) Ground Continuity Connector Terminal D1 4 Existed Is the inspection result normal?
YES
GO TO STEP 4 .
NO
Repair or replace harness.
- CHECK DOOR KEY CYLINDER SWITCH
Refer to COMPONENT INSPECTION .
Is the inspection result normal?
YES
GO TO STEP 5 .
NO
Replace front door lock assembly (driver side).
- CHECK INTERMITTENT INCIDENT
Refer to INTERMITTENT INCIDENT .
INSPECTION END