Diagnosis Procedure

Check signal between BCM harness connector and ground using oscilloscope.

(+)		(-)	Condition		Signal (Reference value)
BCM
Connector	Terminal
M15	101, 102	Ground	When pressing the trunk lid opener request switch with all doors are locked and ignition switch OFF	When Intelligent Key is not in the antenna detection area	Courtesy of NISSAN NORTH AMERICA, INC.
				When Intelligent Key is in the antenna detection area	Courtesy of NISSAN NORTH AMERICA, INC.

Is the inspection result normal?

YES 

Replace BCM. Refer to REMOVAL AND INSTALLATION .

NO 

GO TO STEP 2  .

1. Turn ignition switch OFF.
2. Disconnect BCM connector and outside key antenna (rear bumper) connector.
3. Check continuity between BCM harness connector and outside key antenna (rear bumper) harness connector.

   BCM		Outside key antenna (rear bumper)		Continuity
   Connector	Terminal	Connector	Terminal
   M15	101	B96	2	Existed
   	102		1

4. Check continuity between BCM harness connector and ground.

   BCM		Ground	Continuity
   Connector	Terminal
   M15	101		Not existed
   	102

Is the inspection result normal?

YES 

GO TO STEP 3  .

NO 

Repair or replace harness.

1. Replace outside key antenna (rear bumper). (New antenna or other antenna)
2. Connect BCM and outside key antenna (rear bumper) connector.
3. Check signal between BCM harness connector and ground using oscilloscope.

   (+)		(-)	Condition		Signal (Reference value)
   BCM
   Connector	Terminal
   M15	101, 102	Ground	When pressing the trunk lid opener request switch with all doors are locked and ignition switch OFF	When Intelligent Key is not in the antenna detection area	Courtesy of NISSAN NORTH AMERICA, INC.
   				When Intelligent Key is in the antenna detection area	Courtesy of NISSAN NORTH AMERICA, INC.

Is the inspection result normal?

YES 

Replace outside key antenna (rear bumper).

NO 

Replace BCM. Refer to REMOVAL AND INSTALLATION .