Diagnostic Test

1. Turn ignition switch OFF.
2. Check that the following fuses are not blown (open).
   VR30DDTT ENGINE MODELS
   
   

   Signal name	Fuse No.	Capacity
   Battery power supply	4	5 A
   Ignition power supply	12	10 A

   2.0L TURBO GASOLINE ENGINE MODELS
   
   

   Signal name	Fuse No.	Capacity
   Battery power supply	85	10 A
   Ignition power supply	77	10 A

Is the fuse blown (open)?

YES 

Replace the blown fuse after repairing the affected circuit if a fuse is blown (open).

NO 

GO TO STEP 2  .

1. Disconnect auto anti - dazzling inside mirror connector.
2. Turn ignition switch ON.
3. Check voltage between auto anti - dazzling inside mirror harness connector and ground.

   +		-	Voltage
   Auto anti - dazzling inside mirror
   Connector	Terminal
   R9	6	Ground	9 - 16 V
   	10

Is the inspection result normal?

YES 

GO TO STEP 3  .

NO 

Repair or replace harness.

1. Turn ignition switch OFF.
2. Check continuity between auto anti - dazzling inside mirror harness connector and ground.

   Auto anti - dazzling inside mirror		-	Continuity
   Connector	Terminal
   R9	3	Ground	Existed

Is the inspection result normal?

YES 

Power supply and ground circuit are normal.

NO 

Repair or replace harness.