Diagnostic Test

1. Turn ignition switch OFF.
2. Check that the following fuse is not blown (open).
   VR30DDTT ENGINE MODELS
   
   

   Signal name	Fuse No.	Capacity
   Ignition power supply	14	5 A

   2.0L TURBO GASOLINE ENGINE MODELS
   
   

   Signal name	Fuse No.	Capacity
   Ignition power supply	77	10 A

Is the fuse blown (open)?

YES 

Replace the blown fuse after repairing the affected circuit if a fuse is blown (open).

NO 

GO TO STEP 2  .

1. Disconnect AFS control unit connector.
2. Turn ignition switch ON.
3. Check voltage between AFS control unit harness connector and ground.

   +		-	Voltage
   AFS control unit
   Connector	Terminal
   M4	12	Ground	9 - 16 V

Is the inspection result normal?

YES 

GO TO STEP 3  .

NO 

Repair or replace harness.

1. Turn ignition switch OFF.
2. Check continuity between AFS control unit harness connector and ground.

   AFS control unit		-	Continuity
   Connector	Terminal
   M4	11	Ground	Existed

Is the inspection result normal?

YES 

Power supply and ground circuit are normal.

NO 

Repair or replace harness.