Diagnostic Test

1. Turn ignition switch OFF.
2. Disconnect front combination lamp connector.
3. Turn ignition switch ON.
4. Check voltage between front combination lamp harness connector and ground.

   +			-	Voltage (Approx.)
   Front combination lamp
   Connector		Terminal	Ground	12 V
   RH	E42	2
   LH	E41

Is the inspection result normal?

YES 

Replace front combination lamp. Refer to REMOVAL AND INSTALLATION .

NO 

GO TO STEP 2  .

1. Turn ignition switch OFF.
2. Disconnect combination meter connector.
3. Check continuity between combination meter harness connector and front combination lamp harness connector.

   Combination meter			Front combination lamp		Continuity
   Connector		Terminal	Connector	Terminal
   RH	M57	12	E42	2	Existed
   LH		13	E41

Is the inspection result normal?

YES 

Replace combination lamp. Refer to REMOVAL AND INSTALLATION .

NO 

Repair or replace harness.