Diagnostic Test

1. Turn ignition switch OFF.
2. Check that the following fuses are not blown (open).

Is the fuse blown (open)?

YES 

Replace the blown fuse after repairing the affected circuit if a fuse is blown (open).

NO 

GO TO STEP 2. 

1. Remove daytime running light relay.
2. Check voltage between daytime running light relay harness connector and ground.

   +		-	Voltage (Approx.)
   Daytime running light relay
   Connector	Terminal
   E104	2	Ground	Battery voltage
   	5
   	7

Is the inspection result normal?

YES 

GO TO STEP 3. 

NO 

Repair or replace harness.

Check daytime running light relay. Refer to COMPONENT INSPECTION .

Is the inspection result normal?

YES 

GO TO STEP 4. 

NO 

Replace daytime running light relay.

With CONSULT

1. Install daytime running light relay.
2. Turn ignition switch ON.
3. Select "HEAD LAMP" of "BCM" using CONSULT.
4. Select "DAYTIME RUNNING LIGHT" in "Active Test" mode.
5. With operating the test item, check voltage between IPDM E/R harness connector and ground.

   +		-	Test item		Voltage
   IPDM E/R
   Connector	Terminal
   E126	85	Ground	DAYTIME RUNNING LIGHT	On	0 - 1 V
   				Off	9 - 16 V

Is the inspection result normal?

YES 

GO TO STEP 7. 

NO-1 

Fixed at 0 - 1 V: GO TO STEP 6. 

NO-2 

Fixed at 9 - 16 V: GO TO STEP 5. 

With CONSULT

1. Select "DTRL REQ" in "Data Monitor" mode of "IPDM E/R" using CONSULT.
2. With operating the daytime running light ON condition, check the monitor status.

Is the inspection result normal?

YES 

Replace IPDM E/R. Refer to REMOVAL AND INSTALLATION .

NO 

Replace BCM. Refer to REMOVAL AND INSTALLATION .

1. Turn ignition switch OFF.
2. Remove daytime running light relay.
3. Disconnect IPDM E/R harness connector.
4. Check continuity between IPDM E/R harness connector and daytime running light relay harness connector.

   IPDM E/R		Daytime running light relay		Continuity
   Connector	Terminal	Connector	Terminal
   E126	85	E104	1	Existed

Is the inspection result normal?

YES 

Replace IPDM E/R. Refer to REMOVAL AND INSTALLATION .

NO 

Repair or replace harness.

1. Turn ignition switch OFF.
2. Remove daytime running light relay.
3. Disconnect front combination lamp connector.
4. Check continuity between daytime running light relay harness connector and front combination lamp harness connector.

   Daytime running light relay			Front combination lamp		Continuity
   Connector		Terminal	Connector	Terminal
   RH	E104	6	E42	1	Existed
   LH		3	E41

Is the inspection result normal?

YES 

GO TO STEP 8  .

NO 

Repair or replace harness.

Check continuity between front combination lamp harness connector and ground.

Is the inspection result normal?

YES 

Replace front combination lamp. Refer to REMOVAL AND INSTALLATION .

NO 

Repair or replace harness.