Diagnostic Test

1. Turn ignition switch OFF.
2. Check that the following fuse is not blown (open).

Is the fuse blown (open)?

YES 

Replace the blown fuse after repairing the affected circuit if a fuse is blown (open).

NO 

GO TO STEP 2. 

1. Remove back - up lamp relay.
2. Check voltage between back - up lamp relay harness connector and ground.

   +		-	Voltage (Approx.)
   Back - up lamp relay
   Connector	Terminal
   M97	1	Ground	Battery voltage
   	3

Is the inspection result normal?

YES 

GO TO STEP 3. 

NO 

Repair or replace harness.

Check back - up lamp relay. Refer to COMPONENT INSPECTION .

Is the inspection result normal?

YES 

GO TO STEP 4. 

NO 

Replace back - up lamp relay.

With CONSULT

1. Install back - up lamp relay.
2. Turn ignition switch ON.
3. With operating the selector lever, check voltage between A/T assembly harness connector and ground.

   +		-	Condition		Voltage (Approx.)
   A/T assembly
   Connector	Terminal
   F2	7	Ground	Selector lever position	"R"	0 V
   				Other than above	Battery voltage

Is the inspection result normal?

YES 

GO TO STEP 7. 

NO-1 

Fixed at 0 - 1 V: GO TO STEP 5. 

NO-2 

Fixed at 9 - 16 V: Replace control valve & TCM. Refer to REMOVAL AND INSTALLATION .

1. Turn ignition switch OFF.
2. Remove back - up lamp relay.
3. Disconnect A/T assembly harness connector.
4. Check continuity between A/T assembly harness connector and back - up lamp relay harness connector.

   A/T assembly		Back - up lamp relay		Continuity
   Connector	Terminal	Connector	Terminal
   F2	7	M97	2	Existed

Is the inspection result normal?

YES 

GO TO STEP 6. 

NO 

Repair or replace harness.

1. Remove joint connector. Refer to EXPLODED VIEW WITH TORQUE SPECIFICATIONS .
2. Check the continuity between joint connector terminals.

   A/T assembly harness connector side	TCM harness connector side	Continuity
   Terminal	Terminal
   7	7	Existed

Is the inspection result normal?

YES 

Replace control valve & TCM. Refer to REMOVAL AND INSTALLATION .

NO 

Replace joint connector.

1. Turn ignition switch OFF.
2. Remove back - up lamp relay.
3. Disconnect rear combination lamp (trunk lid side) connector.
4. Check continuity between back - up lamp relay harness connector and rear combination lamp (trunk lid side) harness connector.

   Back - up lamp relay			Rear combination lamp (trunk lid side)		Continuity
   Connector		Terminal	Connector	Terminal
   RH	M97	5	T52	2	Existed
   LH			T51

Is the inspection result normal?

YES 

GO TO STEP 8  .

NO 

Repair or replace harness.

Check continuity between rear combination lamp (trunk lid side) harness connector and ground.

Is the inspection result normal?

YES 

Replace rear combination lamp (trunk lid side). Refer to REMOVAL AND INSTALLATION .

NO 

Repair or replace harness.