Symptom Table
- Perform "Data Monitor" of CONSULT to check for any malfunctioning item.
- Check the malfunction combinations.
Malfunction item:
Data monitor item Malfunction combination FR WIPER HI FR WIPER LOW FR WASHER SW FR WIPER INT INT VOLUME TURN SIGNAL R TURN SIGNAL L TAIL LAMP SW HI BEAM SW HEAD LAMP SW 1 HEAD LAMP SW 2 PASSING SW AUTO LIGHT SW FR FOG SW * * * * A * * * * B * * * C * * * D * * E * * F * * G * * * H * * * * I * * * * J All Items K If only one item is detected or the item is not applicable to the combinations A to K L All Items are normal M - Identify the malfunctioning part from the agreed combination and repair or replace the part.
Malfunction combination Malfunctioning part Repair or replace A Combination switch INPUT 1 circuit Inspect the combination switch output circuit applicable to the malfunctioning part. Refer to DIAGNOSIS PROCEDURE . B Combination switch INPUT 2 circuit C Combination switch INPUT 3 circuit D Combination switch INPUT 4 circuit E Combination switch INPUT 5 circuit F Combination switch OUTPUT 1 circuit Inspect the combination switch input circuit applicable to the malfunctioning part. Refer to DIAGNOSIS PROCEDURE . G Combination switch OUTPUT 2 circuit H Combination switch OUTPUT 3 circuit I Combination switch OUTPUT 4 circuit J Combination switch OUTPUT 5 circuit K BCM Replace BCM. Refer to REMOVAL AND INSTALLATION . L Combination switch Replace combination switch. Refer to REMOVAL AND INSTALLATION . M Connector and harness Check intermittent incident. Refer to INTERMITTENT INCIDENT .