DTC Confirmation Procedure
WARNING: This page is about a different variant/trim than selected.
- PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
GO TO STEP 2 .
- CHECK DTC DETECTION
With CONSULT
- Turn ignition switch ON and wait 2 seconds or more.
- Check DTC.
Is "U0300" detected?
YES
Go to DIAGNOSIS PROCEDURE .
NO-1
To check malfunction symptom before repair: Refer to INTERMITTENT INCIDENT .
NO-2
Confirmation after repair: INSPECTION END