DTC Confirmation Procedure
WARNING: This page is about a different variant/trim than selected.
- PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.
GO TO STEP 2 .
- CHECK DTC DETECTION
With CONSULT
- Start the engine.
- Select "BATTERY VOLT" and "SLCT LVR POSI" in "Data Monitor" in "TRANSMISSION".
- Shift the selector lever to "N" position.
- Maintain the following conditions for 5 seconds or more.
BATTERY VOLT : 9 V or more VHCL/S SE-A/T : 10 km/h (7 MPH) or more - Check DTC.
With GST
Follow the procedure "With CONSULT".
Is "P0745" detected?
YES
Go to DIAGNOSIS PROCEDURE .
NO-1
To check malfunction symptom before repair: Refer to INTERMITTENT INCIDENT .
NO-2
Confirmation after repair: INSPECTION END