DTC Confirmation Procedure
WARNING: This page is about a different variant/trim than selected.
CAUTION:
- "DIAGNOSIS PROCEDURE " must be performed before starting "DTC CONFIRMATION PROCEDURE".
- Never perform "DTC CONFIRMATION PROCEDURE" before completing the repair, which may cause secondary malfunction.
- Always drive vehicle at a safe speed.
- PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.
GO TO STEP 2 .
- CHECK DTC DETECTION
With CONSULT
- Start the engine.
- Select "Self Diagnostic Results" in "ENGINE".
- Drive vehicle under the similar conditions to (1st trip) Freeze Frame Data for 10 minutes. Refer to the table below.
Hold the accelerator pedal as steady as possible.
ENGINE SPEED Same value as the Freeze Frame Data. VEHICLE SPEED Same value as the Freeze Frame Data. B/FUEL SCHDL Same value as the Freeze Frame Data.
With GST
Follow the procedure "With CONSULT".
Is "P0730" detected?
YES
Go to DIAGNOSIS PROCEDURE .
NO
INSPECTION END