DTC Confirmation Procedure
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Always drive vehicle at a safe speed.
- PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.
GO TO STEP 2 .
- CHECK DTC DETECTION
With CONSULT
- Start the engine.
- Select "SLCT LVR POSI", "GEAR", "VHCL/S SE-A/T", "CLSD THL POS" and "ENGINE SPEED" in "Data Monitor" in "TRANSMISSION".
- Drive vehicle and maintain the following conditions for 5 seconds or more.CAUTION:
Keep the same gear position.
NOTE:Driving the vehicle uphill (increased engine load) will help maintain the driving conditions required for this test.
SLCT LVR POSI : D GEAR : 2nd, 3rd, 4th, 5th or 6th VHCL/S SE-A/T : More than 40 km/h (25 MPH) CLSD THL POS : OFF ENGINE SPEED : More than 1, 500 RPM - Check DTC.
With GST
Follow the procedure "With CONSULT".
Is "P0717" detected?
YES
Go to DIAGNOSIS PROCEDURE .
NO-1
To check malfunction symptom before repair: Refer to INTERMITTENT INCIDENT .
NO-2
Confirmation after repair: INSPECTION END