LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2016 >> Q50 Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 51 (Automatic Transmission (Diagnostic Trouble Codes (DTCS) P0750-P2807 And Circuit Diagnosis) (Hybrid)) >> DTC / Circuit Diagnosis >> Selector Lever Position Indicator >> Component Inspection (Selector Lever Position Indicator)

Component Inspection (Selector Lever Position Indicator)

WARNING: This page is about a different variant/trim than selected.

  1. CHECK SELECTOR LEVER POSITION INDICATOR

    Check that selector lever position indicator lamps turn on.

    CAUTION:

    Connect the fuse between the terminals when applying the voltage.

    Selector lever position indicator Condition Status
    + (fuse) -
    Terminal
    2 7 Apply 12 V direct current between terminals 2 and 7. "N" position indicator lamp turns on.
    3 Apply 12 V direct current between terminals 3 and 7. "D" position indicator lamp turns on.
    4 Apply 12 V direct current between terminals 4 and 7. "R" position indicator lamp turns on.
    5 Apply 12 V direct current between terminals 5 and 7. "P" position indicator lamp turns on.
    6 9 Apply 12 V direct current between terminals 6 and 9. "M" mode indicator lamp turns on.
    10 11 Apply 12 V direct current between terminals 10 and 11. Illumination lamp turns on.

    Is the inspection result normal?

    YES 

    INSPECTION END

    NO 

    Replace selector lever position indicator. Refer to REMOVAL AND INSTALLATION .

scientia non olet · About LEMON Manuals