DTC Confirmation Procedure
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Always drive vehicle at a safe speed.
- PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.
GO TO STEP 2 .
- CHECK DTC DETECTION
With CONSULT
- Start the engine.
- Select "SLCT LVR POSI" and "VHCL/S SE-A/T" in "Data Monitor" in "TRANSMISSION".
- Drive vehicle and maintain the following conditions for 5 seconds or more.
SLCT LVR POSI : D VHCL/S SE-A/T : 10 km/h (7 MPH) or more - Check DTC.
Is "P1889" detected?
YES
Go to DIAGNOSIS PROCEDURE .
NO-1
To check malfunction symptom before repair: Refer to INTERMITTENT INCIDENT .
NO-2
Confirmation after repair: INSPECTION END