Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

CHECK SUB ELECTRIC OIL PUMP RELAY

Disconnect sub electric oil pump relay. Refer to COMPONENT LOCATION .
Apply 12V direct current between sub electric oil pump relay terminals 1 and 2.
CAUTION:
- Never make the terminals short.
- Connect the fuse between the terminals when applying the voltage.

Check continuity between sub electric oil pump relay terminals 3 and 5.

Sub electric oil pump relay	Condition	Continuity
Terminal	Condition	Continuity
3 - 5	Apply 12 V direct current between terminals 1 and 2.	Existed
3 - 5	Does not apply 12 V direct current between terminals 1 and 2.	Not existed

Is the inspection result normal?

YES

INSPECTION END

Replace sub electric oil pump relay.