Diagnostic Test

With CONSULT 

1. Turn ignition switch ON.
2. Select "MANU MODE SW", "NON M MODE SW", "UP SW LEVER" and "DOWN SW LEVER" in "Data Monitor" in "TRANSMISSION".
3. Check the ON/OFF operations of each monitor item.

   Item	Monitor Item	Condition	Status
   Manual mode switch	MANU MODE SW	Selector lever is shifted to manual shift gate side	ON
   		Other than the above	OFF
   	NON M-MODE SW	Selector lever is shifted to manual shift gate side	OFF
   		Other than the above	ON
   	UP SW LEVER	Selector lever is shifted to + side	ON
   		Other than the above	OFF
   	DOWN SW LEVER	Selector lever is shifted to - side	ON
   		Other than the above	OFF

Without CONSULT 

Drive the vehicle in manual mode, and then check that indication of shift position indicator matches with the actual gear position.

1. Shift the selector lever to UP side, and then accelerate from 1GR to 7GR.
2. Shift the selector lever to DOWN side, and then decelerate from 7GR to 1GR.

GO TO STEP 2  .

1. Turn ignition switch OFF.
2. Disconnect A/T shift selector connector.
3. Turn ignition switch ON.
4. Check voltage between A/T shift selector harness connector terminals.

   A/T shift selector			Voltage (Approx.)
   Connector	+	-
   	Terminal
   M7	1	4	12 V
   	2
   	3
   	5

Is the inspection result normal?

YES 

GO TO STEP 3  .

NO 

GO TO STEP 4  .

1. Turn ignition switch OFF.
2. Check manual mode switch. Refer to COMPONENT INSPECTION (MANUAL MODE SWITCH) .

Is the inspection result normal?

YES 

GO TO STEP 7  .

NO 

Repair or replace damaged parts.

1. Turn ignition switch OFF.
2. Check continuity between A/T shift selector harness connector terminal and ground.

   A/T shift selector		-	Continuity
   Connector	Terminal
   M7	4	Ground	Existed

Is the inspection result normal?

YES 

GO TO STEP 5  .

NO 

Repair or replace damaged parts.

1. Disconnect combination meter connector.
2. Check continuity between A/T shift selector harness connector terminals and combination meter harness connector terminals.

   A/T shift selector		Combination meter		Continuity
   Connector	Terminal	Connector	Terminal
   M7	1	M57	30	Existed
   	2		33
   	3		32
   	5		31

Is the inspection result normal?

YES 

GO TO STEP 6  .

NO 

Repair or replace damaged parts.

Check continuity between A/T shift selector harness connector terminals and ground.

Is the inspection result normal?

YES 

GO TO STEP 7  .

NO 

Repair or replace damaged parts.

Refer to INTERMITTENT INCIDENT .

Is the inspection result normal?

YES 

GO TO STEP 8  .

NO 

Repair or replace damaged parts.

1. Reconnect all the connectors.
2. Turn ignition switch ON.
3. Select "M RANGE SW," "NM RANGE SW," "AT SFT UP SW," and "AT SFT DWN SW," in "Data Monitor" in "METER/M&A."
4. Check the ON/OFF operations of each monitor item. Refer to REFERENCE VALUE .

Is the inspection result normal?

YES 

Replace transmission assembly. Refer to REMOVAL AND INSTALLATION .

NO 

Replace combination meter. Refer to REMOVAL AND INSTALLATION .