DTC Confirmation Procedure
WARNING: This page is about a different variant/trim than selected.
- PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.
GO TO STEP 2 .
- CHECK DTC DETECTION
With CONSULT
- Set the vehicle to READY.
- Drive vehicle and maintain the following conditions for 5 seconds or more.
BATTERY VOLT : 9 V or more SLCT LVR POSI : D or R - Stop the vehicle.
- Check DTC.
With GST
Follow the procedure "With CONSULT".
Is "P175A" detected?
YES
Go to DIAGNOSIS PROCEDURE .
NO-1
To check malfunction symptom before repair: Refer to INTERMITTENT INCIDENT .
NO-2
Confirmation after repair: INSPECTION END