Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect touch sensor RH connector.
3. Check voltage between touch sensor RH harness connector and ground.

   (+)		(-)	Voltage (Approx.)
   Touch sensor RH
   Connector	Terminal
   D108	1	Ground	6 V

Is the inspection result normal?

YES 

GO TO STEP 3  .

NO 

GO TO STEP 2  .

1. Disconnect automatic back door control module connector.
2. Check continuity between automatic back door control module harness connector and touch sensor RH harness connector.

   Automatic back door control module		Touch sensor RH		Continuity
   Connector	Terminal	Connector	Terminal
   B26	16	D108	1	Existed

3. Check continuity between automatic back door control module harness connector and ground.

   Automatic back door control module		Ground	Continuity
   Connector	Terminal
   B26	16		Not existed

Is the inspection result normal?

YES 

Replace automatic back door control module. Refer to REMOVAL AND INSTALLATION .

NO 

Repair or replace harness.

Check continuity between automatic back door control module harness connector and touch sensor RH harness connector.

Is the inspection result normal?

YES 

GO TO STEP 4  .

NO 

Repair or replace harness.

Refer to COMPONENT INSPECTION .

Is the inspection result normal?

YES 

GO TO STEP 5  .

NO 

Replace touch sensor RH.

Refer to INTERMITTENT INCIDENT .

INSPECTION END