Diagnosis Procedure
- CHECK POWER SUPPLY
- Turn ignition switch OFF.
- Disconnect auto anti-dazzling inside mirror (integrated homelink transmitter) connector.
- Check voltage between auto anti-dazzling inside mirror (integrated homelink transmitter) harness connector and ground.
(+) (-) Voltage
(Approx.)Auto anti-dazzling inside mirror
(Integrated homelink transmitter)Connector Terminal R25 6 Ground Battery voltage 10 Is the inspection result normal?
YES
GO TO STEP 2 .
NO-1
Check 10 A fuse [No. 6 located in the fuse block (J/B)].
NO-2
Harness for open or short between fuse and auto anti-dazzling inside mirror (integrated homelink transmitter).
- CHECK GROUND CIRCUIT
Check continuity between auto anti-dazzling inside mirror (integrated homelink transmitter) harness connector and ground.
Auto anti-dazzling inside mirror
(Integrated homelink transmitter)Ground Continuity Connector Terminal R25 8 Existed Is the inspection result normal?
YES
GO TO STEP 3 .
NO
Repair or replace harness.
- CHECK INTERMITTENT INCIDENT
Refer to INTERMITTENT INCIDENT .
INSPECTION END