Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect back door lock assembly connector.
3. Check voltage between back door lock assembly harness connector and ground.

   (+)		(-)	Condition		Voltage (Approx.)
   Back door lock assembly
   Connector	Terminal
   D157	1	Ground	Back door opener switch	Pressed	Battery voltage
   	2			Released	0 V

Is the inspection result normal?

YES 

Replace back door lock assembly.

NO 

GO TO STEP 2  .

1. Disconnect automatic back door control module connector.
2. Check continuity between automatic back door control module harness connector and back door lock assembly harness connector.

   Automatic back door control module		Back door lock assembly		Continuity
   Connector	Terminal	Connector	Terminal
   B26	11	D157	1	Existed
   	12		2

3. Check continuity between automatic back door control module harness connector and ground.

   Automatic back door control module		Ground	Continuity
   Connector	Terminal
   B26	11		Not existed
   	12

Is the inspection result normal?

YES 

Replace automatic back door control module. Refer to REMOVAL AND INSTALLATION .

NO 

Repair or replace harness.