Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect around view monitor control unit connector and door mirror (driver side) connector.
3. Check continuity between around view monitor control unit harness connector and door mirror (driver side) harness connector.

   Around view monitor control unit		Door mirror (driver side)		Continuity
   Connector	Terminal	Connector	Terminal
   M61	55	D3	3	Existed

4. Check continuity between around view monitor control unit harness connector and ground.

   Around view monitor control unit		Ground	Continuity
   Connector	Terminal
   M61	55		Not existed

Is inspection result normal?

YES 

GO TO STEP 2  .

NO 

Repair harness or connector.

1. Connect around view monitor control unit connector and door mirror (driver side) connector.
2. Turn ignition switch ON.
3. Check signal between around view monitor control unit harness connector and ground.

   (+)		(-)	Condition	Reference value
   Around view monitor control unit
   Connector	Terminal
   M61	55	Ground	"CAMERA" switch is ON or shift position is "R".	Courtesy of NISSAN NORTH AMERICA, INC.

Is inspection result normal?

YES 

Replace around view monitor control unit. Refer to REMOVAL AND INSTALLATION .

NO 

Replace side camera LH. Refer to REMOVAL AND INSTALLATION .