Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect around view monitor control unit connector and rear camera connector.
3. Check continuity between around view monitor control unit harness connector and rear camera harness connector.

   Around view monitor control unit		Rear camera		Continuity
   Connector	Terminal	Connector	Terminal
   M61	49	D164	4	Existed

4. Check continuity between around view monitor control unit harness connector and ground.

   Around view monitor control unit		Ground	Continuity
   Connector	Terminal
   M61	49		Not existed

Is inspection result normal?

YES 

GO TO STEP 2  .

NO 

Repair harness or connector.

1. Connect around view monitor control unit connector and rear camera connector.
2. Turn ignition switch ON.
3. Check signal between around view monitor control unit harness connector and ground.

   (+)		(-)	Condition	Reference value
   Around view monitor control unit
   Connector	Terminal
   M61	49	Ground	"CAMERA" switch is ON or shift position is "R".	Courtesy of NISSAN NORTH AMERICA, INC.

Is inspection result normal?

YES 

Replace around view monitor control unit. Refer to REMOVAL AND INSTALLATION .

NO 

Replace rear camera. Refer to REMOVAL AND INSTALLATION .