Diagnosis Procedure
- CHECK FUSE
Check for blown fuses.
Power source Fuse No. Battery 35 Is the inspection result normal?
YES
GO TO STEP 2 .
NO
Be sure to eliminate cause of malfunction before installing new fuse.
- CHECK POWER SUPPLY CIRCUIT
Check voltage between headrest display unit harness connector and ground.
Signal name Connector Terminal Ignition switch position Value (Approx.) Battery power supply B554* 1
B574* 22 OFF Battery voltage 4 - * 1: Headrest display unit LH
- * 2: Headrest display unit RH
Is the inspection result normal?
YES
GO TO STEP 3 .
NO
Check harness between headrest display unit and fuse.
- CHECK GROUND CIRCUIT
- Turn ignition switch OFF.
- Disconnect headrest display unit connector.
- Check continuity between headrest display unit harness connector and ground.
Signal name Connector Terminal Ignition switch position Continuity Ground B554* 1
B574* 21 OFF Existed 3
- * 1: Headrest display unit LH
- * 2: Headrest display unit RH
Is the inspection result normal?
YES
INSPECTION END
NO
Repair harness or connector.