Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect around view monitor control unit connector and door mirror (passenger side) connector.
3. Check continuity between around view monitor control unit harness connector and door mirror (passenger side) harness connector.

   Around view monitor control unit		Door mirror (passenger side)		Continuity
   Connector	Terminals	Connector	Terminals
   M48	5	D23	4	Existed

4. Check continuity between around view monitor control unit harness connector and ground.

   Around view monitor control unit		Ground	Continuity
   Connector	Terminal
   M48	5		Not existed

Is inspection result normal?

YES 

Replace around view monitor control unit. Refer to REMOVAL AND INSTALLATION .

NO 

Repair harness or connector.