Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect sonar control unit connector and front center sensor RH connector.
3. Check continuity between sonar control unit connector and front center sensor RH connector.

   Sonar control unit		Front center sensor RH		Continuity
   Connector	Terminal	Connector	Terminal
   M47	10	E210	2	Existed

4. Check for continuity between sonar control unit and ground.

   Sonar control unit		Ground	Continuity
   Connector	Terminal
   M47	10		Not existed

Is the check result normal?

YES 

GO TO STEP 2. 

NO 

Repair the harnesses or connectors.

Check continuity between sonar control unit connector and front center sensor RH connector.

Is the check result normal?

YES 

Replace front center sensor RH. Refer to REMOVAL AND INSTALLATION .

NO 

Repair the harnesses or connectors.