Diagnosis Procedure
- CHECK WASHER LEVEL SWITCH SIGNAL CIRCUIT
- Turn ignition switch OFF.
- Disconnect combination meter connector and washer level switch connector.
- Check continuity between combination meter harness connector and washer level switch harness connector.
Terminals Continuity Combination meter Washer level switch Connector Terminal Connector Terminal M34 29 E54 1 Existed - Check continuity between combination meter harness connector and ground.
Terminals Continuity Combination meter Ground Connector Terminal M34 29 Not existed
Is the inspection result normal?
YES
GO TO STEP 2.
NO
Repair harness or connector.
- CHECK WASHER LEVEL SWITCH GROUND CIRCUIT
Check continuity between washer level switch connector and ground.
Terminals Continuity Washer level switch Ground Connector Terminal E54 2 Existed Is the inspection result normal?
YES
INSPECTION END
NO
Repair harness or connector.