Component Inspection

1. Turn ignition switch OFF.
2. Disconnect trip reset and illumination control switch connector.
3. Check trip reset and illumination control switch.

   Terminals		Condition	Continuity
   Trip reset and illumination control switch
   5	6	When trip reset switch is pressed	Existed
   		Other than the above	Not existed
   3		When illumination control switch (+) is pressed	Existed
   		Other than the above	Not existed
   4		When illumination control switch (-) is pressed	Existed
   		Other than the above	Not existed

Is the inspection result normal?

YES 

INSPECTION END

NO 

Replace trip reset and illumination control switch. Refer to REMOVAL AND INSTALLATION .