Torque Converter And Converter Housing Oil Seal: Assembly

Assembly is in the reverse order of disassembly.

• Drive converter housing oil seal (1) evenly using a drift (A) (commercial service tool) so that converter housing oil seal protrudes by the dimension (B) respectively.
  Fig 1: Installing Converter Housing Oil Seal

  Courtesy of NISSAN NORTH AMERICA, INC.

  Unit: mm (in)

  Commercial service tool: (A)	Outer diameter: 65 (2.56)
  	Inner diameter: 60 (2.36)

  (2)	: Transaxle assembly

  Unit: mm (in)

  Dimension (B)

  1.0 +- 0.5 (0.039 +- 0.020)

  Fig 2: Identifying Converter Housing Oil Seal Protrusion Dimension

  Courtesy of NISSAN NORTH AMERICA, INC.
  NOTE:

  Converter housing oil seal pulling direction is used as the reference.

• After completing installation, check for CVT fluid leaks and CVT fluid level. Refer to INSPECTION .
• Attach the pawl (A) of the torque converter to the drive sprocket hole (B) on the transaxle assembly side.
  Fig 3: Identifying Drive Sprocket Hole And Pawl

  Courtesy of NISSAN NORTH AMERICA, INC.
  CAUTION:

  • Rotate the torque converter for installing torque converter.
  • Do not damage the bushing inside the torque converter sleeve when installing the converter housing oil seal.