LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission (Re0F10J) (Diagnostic Trouble Codes (DTCS), Symptom Diagnosis And R & I) (Except Hybrid) >> Symptom Diagnosis >> CVT Control System >> Symptom Tables >> Symptom Table 2

Symptom Table 2

Symptom Torque converter Transmission range switch Oil pump Forward clutch Reverse brake Planetary gear Bearings Parking mechanism Stop lamp switch Shift lock solenoid CVT shift selector
EXPLODED VIEW  EXPLODED VIEW  COMPONENT INSPECTION (STOP LAMP SWITCH)  COMPONENT FUNCTION CHECK  EXPLODED VIEW 
Shift Shock Large shock (N→ D position)   2   1              
Large shock (N→ R position)   2     1            
Shock is too large for lock-up. 1                    
Slips/Will Not Engage Vehicle cannot be started from D position.   3 1 2              
Vehicle cannot be started from R position.   4 1   2     3      
Does not lock-up. 1 3 2                
Does not hold lock-up condition. 1 3 2                
Lock-up is not released. 1   2                
With selector lever in D position, acceleration is extremely poor. 1 3   2              
With selector lever in R position, acceleration is extremely poor. 1 4 2   3            
Slips at lock-up. 1   2                
Other No creep at all. 1 6 2 4 5 3          
Vehicle cannot run in all positions. 1   2 4 5 3   6      
With selector lever in D position, driving is not possible. 1   2 4   3   5      
With selector lever in R position, driving is not possible. 1   2   4 3   5      
Judder occurs during lock-up. 1                    
Strange noise in D position. 1   2 4   3 5        
Strange noise in R position. 1   2   4 3          
Strange noise in N position. 1   2     3          
Maximum speed low. 1 5 2 4   3          
With selector lever in P position, vehicle does not enter parking condition or, with selector lever in another position, parking condition is not cancelled.               1      
Vehicle runs with CVT in P position.           2   1      
Vehicle runs with CVT in N position.       2 3 1          
Engine stall. 1                    
Engine stalls when selector lever shifted N → D or R. 1                    
Does not shift     1                
Other When brake pedal is depressed with ignition switch ON, selector lever cannot be shifted from P position to other position.                 1 2 3
When brake pedal is not depressed with ignition switch ON, selector lever can be shifted from P position to other position.                 1 2 3