LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission (Re0F10J) (Diagnostic Trouble Codes (DTCS), Symptom Diagnosis And R & I) (Except Hybrid) >> Removal And Installation >> Input Speed Sensor >> Removal And Installation >> Removal

Removal And Installation: Removal

  1. Remove the battery tray. Refer to REMOVAL AND INSTALLATION .
  2. Remove the starter motor. Refer to REMOVAL AND INSTALLATION .
  3. Disconnect the harness connector from the input speed sensor (1).
    Fig 1: Identifying Input Speed Sensor And O-Ring
    G08682921Courtesy of NISSAN NORTH AMERICA, INC.
  4. Remove the input speed sensor bolt, then the input speed sensor (1).
  5. Remove the O-ring (2) from the input speed sensor (1).
    CAUTION:

    Do not reuse O-ring.

scientia non olet · About LEMON Manuals