Component Inspection (Shift Lock Solenoid)

CHECK SHIFT LOCK SOLENOID

Apply voltage to terminals of shift lock solenoid and park position switch (shift selector) connector and check that shift lock solenoid is activated.

CAUTION:

Connect the fuse between the terminals when applying the voltage.
Never cause shorting between terminals.

+ (fuse)	-	Condition	Status
Shift lock solenoid
Terminal
3	4	Apply 12 V between terminals 3 and 4 with the park position switch (shift selector) in the "P" (park) position.	Shift lock solenoid operates

Is the inspection result normal?

YES

Inspection End.

Replace CVT shift selector. Refer to REMOVAL AND INSTALLATION .