DTC Confirmation Procedure

CAUTION:

DIAGNOSIS PROCEDURE must be performed before starting "DTC CONFIRMATION PROCEDURE".
Always drive vehicle at a safe speed.

PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

GO TO STEP 2 .

CHECK DTC DETECTION
1. With the throttle position 1/8, accelerate the vehicle from 0 km/h (0 MPH) to 50 km/h (31 MPH).
2. Drive the vehicle at 50 km/h (31 MPH) constant speed for 15 seconds.
3. Stop the vehicle with a brake force which allows the vehicle to stop in 10 to 20 seconds.
4. Repeat steps 1 to 3 above 5 times.
Is "P17F0" detected?

YES

Go to DIAGNOSIS PROCEDURE .

NO

INSPECTION END