DTC Detection Logic

DTC	CONSULT screen terms (Trouble diagnosis content)	DTC detection condition	Possible cause
P0841	FLUID PRESS SEN/SW A (Transmission Fluid Pressure Sensor/Switch "A" Circuit Range/Performance)	When all of the following conditions are satisfied and this state is maintained for 5 seconds: TCM power supply voltage: More than 11 V DTC other than the applicable DTC is not detected. Primary pulley speed: 300 RPM or more Secondary pulley speed: 250 RPM or more Target speed for shifting: Less than 0.1 seconds Primary pulley pressure is outside the specified value. Pulley ratio: 0.5 - 1.0	Harness or connectors (Secondary pressure sensor circuit is open or shorted.) Harness or connectors (Primary pressure sensor circuit is open or shorted.) Secondary pressure sensor