LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission (Re0F10J) (Diagnostic Trouble Codes (DTCS), Symptom Diagnosis And R & I) (Except Hybrid) >> DTC/Circuit Diagnosis >> DTC P0841: Transmission Fluid Pressure Sen/SW A >> DTC Logic >> DTC Confirmation Procedure

DTC Confirmation Procedure

CAUTION:

Be careful of the driving speed.

  1. PREPARATION BEFORE WORK

    If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

    GO TO STEP 2  .

  2. CHECK DTC DETECTION

    1. Start the engine.
    2. Drive the vehicle.
    3. Maintain the following condition for 10 seconds or more.
      Selector lever : "D" position
      Vehicle speed : Constant speed of 40 km/h (25 MPH)
      CAUTION:

      Also keep the accelerator pedal position constant.

    4. Stop the vehicle.
    5. Check the first trip DTC.

    Is "P0841" detected?

    YES 

    Go to DIAGNOSIS PROCEDURE .

    NO 

    INSPECTION END