DTC Detection Logic

DTC	CONSULT screen terms (Trouble diagnosis content)	DTC detection condition	Possible causes
P0746	PC SOLENOID A (Pressure Control Solenoid A Performance/Stuck Off)	The detecting condition A or detection condition B is detected twice or more (1 second or more later after detection of the first) in the same DC under the following diagnosis conditions: Diagnosis conditions Engine speed: More than 600 RPM Primary pulley speed: More than 450 RPM Idle is not being detected. Acceleration/deceleration speed: - 0.49 m/s² (- 0.05 G) or more The primary pulley speed experienced 300 RPM or more and the secondary pulley speed experienced 250 RPM or more at least once. Secondary pulley speed: More than 150 RPM TCM power supply voltage: More than 11 V Detection condition A Status with the shifting ratio of the primary pulley speed/secondary pulley ratio exceeding 2.825 is 0.2 sec or more continuously. Detection condition B Status with the shifting ratio of the primary pulley speed/secondary pulley ratio exceeding 3.625 is 0.1 sec or more continuously.	Line pressure solenoid valve Control valve assembly

NOTE:

DC stands for "DRIVING CYCLE" and indicates a series of driving cycle of "Ignition switch OFF → ON → driving → OFF".