LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Transfer Case (Except Hybrid)) >> Unit Disassembly And Assembly >> Drive Pinion >> Exploded View

Exploded View

WARNING: This page is about a different variant/trim than selected.
Fig 1: Exploded View Of Transfer Case With Torque Specifications
GNSJSDIA4191GB-191Courtesy of NISSAN NORTH AMERICA, INC.
1. Oil seal 2. Transfer cover 3. Filler plug
4. Gasket 5. Drain plug 6. Oil seal
7. O-ring 8. Ring gear bearing adjusting shim (transfer cover side) 9. Ring gear bearing (transfer cover side)
10. Drive shaft oil seal 11. Ring gear shaft 12. Ring gear bearing (transfer case side)
13. Ring gear bearing adjusting shim (transfer case side) 14. Ring gear 15. Baffle plate
16. Transfer case 17. Plug 18. O-ring
19. Oil seal 20. Dowel pin 21. Drive pinion
22. Drive pinion adjusting shim 23. O-ring 24. Pinion bearing assembly
25. Oil seal 26. Dust cover 27. Companion flange
28. Pinion lock nut        
A. Oil seal lip B. Comply with the assembly procedure when tightening. Refer to ASSEMBLY .    
BOLT : N•m (kg - m, ft - lb)
BOLTIN : N•m (kg - m, in - lb)
DISAS : Always replace after every disassembly.
OIL : Apply gear oil.
OIL* : Apply anti-corrosive oil.
GREASE : Apply multi-purpose grease.
STARF : Select with proper thickness.
scientia non olet · About LEMON Manuals